A: With permanent panel mount module
B: With portable battery module

New Comfort gel, undercut ear seals

Battery Power Module - One 9 volt battery for up to 25 hours of operation.

Pilot Selectable Automatic-Shut Off Feature.

Five foot (extended) coil cord terminating with a 10 pin quick release connector.

Coiled cord assembly connects Battery Power Module to panel intercom/radio.

Same headset can be used with optional panel mount. (H10-56XP)

Dual volume controls let you adjust the level for each ear

Exclusive, patented flex/wire boom for easy, precise microphone placement

Super soft foam filled pillow headpad

NRR - 27 dB passive noise reduction rating plus 17 dB to 22 dB when ENC is turned on

Weight (without cord assembly): 22 oz.

Earphone Type:	Dynamic(ENC)	Noise-Canceling Mic:	M-7A Amplified Electret
Earphone Impedance:	Monaural, 150 Ohms nominal, stereo, 300 Ohms nominal per side	Mic Impedance:	50 ohms +/- 20%
Earphone Sensitivity:	90 dB SPL on flat plate coupler, re 1mW input @ 1KHz	Mic Sensitivity:	400mV RMS ±6dB into 150 ohm load @ 1kHz for 114dB SPL input
Earphone Frequency Response:	100-5,500 Hz	Mic Freq Response:	300Hz--3.5KHz per RTCA DO 214
Earphone Plug:	U-174/U	Mic Plug:	U-174/U
Boom Type:	Patented Flex/Wire	Cord:	5 ft.Coil
Headpad/Hardware:	Super-Soft Headpad,Lightweight Hardware	Weight/Headset Only:	22 oz.

Name of your friend:

E-mail of your friend:

Your name:

Your e-mail:

Your message: 40614G-01 Headset H10-56HXP with permanent panel mount module

Type the characters you see in the picture below.